RICARDO MÁXIMO

MSc Motorsport Engineering

BSc Mechanical Engineering

RACE EXPERIENCE

Estoril Circuit

Oficial Test JuniorGP

Supporting the Estrella Galicia 0,0 team during the official JuniorGP test. Development of setups for ETC and Moto2 riders. Further development of data analysis expertise using 2D, HRC Tooling for the NSF250R, and Mectronic for Triumph Moto2.

Karting Motorland Circuit

Private Test Monlau (ETC)

Private test with the Estrella Galicia 0,0 team. Development of a personal workbook and deepening of knowledge in data acquisition using 2D software, including the creation of engine maps with HRC Tooling.Development of bike setup for rider Mateo Marulanda.

Calafat Circuit

Endurance Race 4h (SSP)

Bike prep, creation of data acquisition wiring harness. Race preparation, pit box operations, strategy, data analysis, and setup adjustments for riders Marc Guillamet and Arnau Sánchez (CBR600RR PC40).Further development of data analysis using 2D and RapidBike Master

Calafat Circuit

Private Test Monlau (ETC)

Private test with the Estrella Galicia 0,0 team. Development of a personal workbook and deepening of knowledge in data acquisition using 2D software, including the creation of engine maps with HRC Tooling.Development of bike setup for rider Joel Mora.

Private test with the Estrella Galicia 0,0 team. Development of a personal workbook and deepening of knowledge in data acquisition using 2D software, including the creation of engine maps with HRC Tooling.Development of bike setup for rider Cesc Obiol.

Mora D’Ebre Circuit

Private Test Monlau (ETC)

Private test with the Estrella Galicia 0,0 team. Development of a personal workbook and deepening of knowledge in data acquisition using 2D software, including the creation of engine maps with HRC Tooling.Development of bike setup for rider Mateo Marulanda.

Catalunya Circuit

Spanish F4 Oficial Test

Support of the Monlau F4 team during the official Spanish F4 test.Development of a base setup for driver Gilles.Further development of Wintax Software.

WORK EXPERIENCE

Head of Performance @ Veicomer

Engine Machinist

Responsible for all operations within the Performance section.This section specializes in cylinder head porting, yielding increased airflow into and out of the combustion chamber.Development of airflow studies using the FlowPro software, analyzing the characteristics and the changes implemented before and after the resizing of the duct and/or combustion chamber.

UNIVERSITY EXPERIENCE

Formula Student @ ISEL

Member of the aerodynamics department. Responsible for R&D and manufacturing of the front and rear wings of the “02” model. Development of CFD skills.Member of the vehicle integration department. Creation and development of multiple components. Development of topological optimization skills.